Safe lifting with Svero!

Sometimes we are asked if you can trust the safety of our products? We will answer that here!

All of our Svero products are manufactured according to the EN 13157 standard and they are tested at the factory where they are produced.

When we develop new products, they are also tested here in Sweden before we launch them. This takes place at RISE, Research Institutes of Sweden AB, in Borås, which is an independent state-owned research institute. We have been testing our products there for 30 years and they are an important partner to us.

It is almost always required that we provide equipment to carry out the tests, and this can include specially manufactured beams that can withstand high loads. The most recent products tested were our new manual push trolleys with capacities of 10 and 20 tons. During the process, the load was up to 80 tons, and then it is very important that both the trolley and the beam are securely fastened!

The tests of the new trolleys went well so they are now in our range of trolleys. You can find more information about them here! And they are safe to use!

20234 – beam trolley 10 ton, 220-300 mm
21234 – beam trolley, geared, 10 ton, 220-300 mm
21274 – beam trolley, geared, 20 ton, 220-300 mm